Listar Diseño Mecánico, Materiales y Procesos - GIDIMA por autor "a98add1326dbb80bf038dda2d817350a"
Mostrando ítems 1-3 de 3
-
A comparative study of the cutting parameter in milling process under different material
Acevedo Peñaloza, Carlos Humberto; Valencia, Guillermo; Coba Salcedo, Milton Fabian (Contemporary Engineering SciencesBulgaria, 2018-06-18)In the present study, the incidence of the variation in feed rate per tooth and depth of cut for SAE 4340 alloy steel and SAE J431 steel castings was analysed and in which material this variation is most noticeable. For ... -
Experimental study of the 2D variability roughness in the honing process of the steel cylinder
Acevedo Peñaloza, Carlos Humberto; Valencia, Guillermo; Coba Salcedo, Milton Fabian (Contemporary Engineering SciencesBulgaria, 2018-05-29)This article presents the study of the surface roughness inside cylinders, machined by honing in industrial honing machines, with a detailed review of the variability of the values obtained in the measurement of the ... -
Experimental study of the correlation the surface roughness 2D and 3D in the honing process of the steel cylinder
Coba Salcedo, Milton Fabian; Acevedo Peñaloza, Carlos Humberto; Valencia, Guillermo (Indian Journal of Science and TechnologyIndia, 2018-08)Objectives: This research proposes the feasibility of working on surfaces obtained by honing with 2D roughness parameters, as the 3D roughness measurement commonly used in the industry requires many hours of measurement ...